Installation
INSTALLATION
PROCEDURE
1. INSTALL HYBRID VEHICLE CONTROL ECU
(a) Install the hybrid vehicle control ECU with the bolt and nut.
Torque:
Bolt :
8.0 N·m {82 kgf·cm, 71 in·lbf}
Nut :
5.5 N·m {56 kgf·cm, 49 in·lbf}
(b) Connect the 4 hybrid vehicle control ECU connectors.
2. INSTALL NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
Click here 
3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here
Removal
REMOVAL
CAUTION / NOTICE / HINT
The
necessary procedures (adjustment, calibration, initialization, or
registration) that must be performed after parts are removed and
installed, or replaced during hybrid vehicle control ECU
removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|
*: When performing learning using the Techstream.
|
| Disconnect cable from negative battery terminal |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
 |
|
Pre-collision system |
|
Intelligent clearance sonar system* |
|
Lighting System (for HV Model with Cornering Light) |
|
Memorize steering angle neutral point |
Parking assist monitor system |
|
|
Panoramic view monitor system |
|
|
Replacement of hybrid vehicle control ECU |
Code registration (Smart key System (for Start Function)) |
- Wireless door lock control system
- Smart key system (for Entry Function)
- Smart key system (for Start Function)
- Steering lock function
|
|
CAUTION:
Be sure to read Precaution thoroughly before servicing.
Click here
NOTICE:
After
turning the power switch off, waiting time may be required before
disconnecting the cable from the negative (-) auxiliary battery
terminal. Therefore, make sure to read the disconnecting the cable from
the negative (-) auxiliary battery terminal notices before proceeding
with work.
Click here
PROCEDURE
1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Click here
2. REMOVE NO. 3 INSTRUMENT PANEL TO COWL BRACE SUB-ASSEMBLY
Click here
3. REMOVE HYBRID VEHICLE CONTROL ECU
| (a) Disconnect the 4 hybrid vehicle control ECU connectors. |
|
| (b) Remove the bolt, nut and hybrid vehicle control ECU. |
|
