Toyota Avalon (XX50): Knock Sensor

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual / Engine / A25a-fxs Engine Control / Knock Sensor

Components

COMPONENTS

ILLUSTRATION

*1

KNOCK CONTROL SENSOR

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

Inspection

INSPECTION

PROCEDURE

1. INSPECT KNOCK CONTROL SENSOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

25°C (77°F)

120 to 280 kΩ

If the result is not as specified, replace the knock control sensor.

*a

Component without harness connected

(Knock Control Sensor)

Installation

INSTALLATION

CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE

1. INSTALL KNOCK CONTROL SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.

Click here

(a) Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

Torque:

21 N·m {214 kgf·cm, 15 ft·lbf}

NOTICE:

  • If the knock control sensor has been struck or dropped, replace it.
  • Make sure that the knock control sensor is in the correct position.

*a

Top

*b

Right of Vehicle

*c

15°

*d

5°

(b) Connect the knock control sensor connector.

2. INSTALL INTAKE MANIFOLD

Click here

3. PERFORM INITIALIZATION

(a) Perform "Inspection After Repair" after replacing the knock control sensor.

Click here

Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

  • Replacement of throttle body assembly
  • Cleaning the deposits from the throttle body assembly
  • Replacement of EGR valve assembly
  • Gas leak from exhaust system is repaired
  • Replacement of knock control sensor

Inspection after repair

  • Poor idle, etc.
  • Engine start function, etc.

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE

1. REMOVE INTAKE MANIFOLD

Click here

2. REMOVE KNOCK CONTROL SENSOR

(a) Disconnect the knock control sensor connector.

(b) Remove the bolt and knock control sensor from the cylinder block sub-assembly.

NOTICE:

If the knock control sensor has been struck or dropped, replace it.

Ignition System

Mass Air Flow Meter

See More:

Toyota Avalon (XX50) 2019-2022 Owners Manual > Steps to take in an emergency: If the electronic key does not operate properly
If communication between the electronic key and vehicle is interrupted or the electronic key cannot be used because the battery is depleted, the smart key system and wireless remote control cannot be used. In such cases, the doors and trunk can be opened and the engine can be started by following t ...

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

© 2025 Copyright engine.tavalon.net
0.2297