Inspection
INSPECTION
PROCEDURE
1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
| (a) Disengage the clamp to disconnect the wire harness protector. |
 |
|
*1 | Wire Harness Protector | | |
(b) Disconnect the engine oil pressure switch assembly connector.
(c) Start the engine.
| (d) Measure the resistance according to the value(s) in the table below.
Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
1 - Engine oil pressure switch assembly body |
Idling | 10 kΩ or higher | |
Engine stopped | Below 1 Ω |
If the result is not as specified, replace the engine oil pressure switch assembly. |
 |
|
*a | Engine Oil Pressure Switch Assembly Body | | |
(e) Connect the engine oil pressure switch assembly connector.
(f) Engage the clamp to connect the wire harness protector.
Installation
INSTALLATION
PROCEDURE
1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
| (a) Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Adhesive: Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
NOTICE:
- Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
- Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.
|
 |
|
*a | Adhesive | |
*b | Oil Inlet Port | | |
(b) Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.
Torque:
15 N·m {153 kgf·cm, 11 ft·lbf}
NOTICE:
Do not start the engine for at least 1 hour after installation.
(c) Connect the engine oil pressure switch assembly connector.
(d) Engage the clamp to connect the wire harness protector.
2. ADD ENGINE OIL
Click here 
3. CHECK ENGINE OIL LEVEL
Click here
4. INSPECT FOR OIL LEAK
Click here
5. INSTALL FRONT FENDER APRON SEAL RH
Click here
