Toyota Avalon (XX50): Active Control Engine Mount(for Rear Side)

*1

REAR ENGINE MOUNTING INSULATOR

*2

VACUUM HOSE

*3

WIRE HARNESS CLAMP BRACKET

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

(c) Align the hole of the rear engine mounting insulator with the protrusion of the rear engine mounting bracket, slide the rear engine mounting insulator onto the rear engine mounting bracket to align the holes and install the rear engine mounting insulator with the bolt.

Torque:

72 N·m {734 kgf·cm, 53 ft·lbf}

(a) Disengage the clamp to separate the vacuum hose.

(c) Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute.

Battery terminal is disconnected/reconnected

Perform steering sensor zero point calibration

Lane departure alert system (w/ Steering Control)

Pre-collision system

Intelligent Clearance Sonar System*1

Lighting System (for Gasoline Model with Cornering Light)

Memorize steering angle neutral point

Parking Assist Monitor System

Panoramic View Monitor System

Replacement of ECM

Vehicle Identification Number (VIN) registration

MIL comes on

ECU communication ID registration (Immobiliser system)

Engine start function

Gas leak from exhaust system is repaired

Inspection after repair

• Poor idle, etc.
• Engine start function, etc.

Replacement of ECM

(If transaxle compensation code read from ECM)

• Perform reset memory*2
• Transfer transaxle compensation code
• Perform road test to allow ECM to learn

• Large shift shock
• Deterioration of fuel efficiency

for Initialization

for Registration

Replacement of ECM

(If transaxle compensation code not read from ECM)

• Perform reset memory*2
• Reset transaxle compensation code
• Perform road test to allow ECM to learn

Replacement of ECM

Code registration (Smart Key System (for Start Function))

• Wireless Door Lock Control System
• Smart Key System (for Entry Function)
• Smart Key System (for Start Function)
• Steering lock function

Suspension, tires, etc.

• Measure ultrasonic sensor detection angle
• Ultrasonic sensor detection angle registration

• Intelligent Clearance Sonar System
• Intuitive Parking Assist System

Rear television camera assembly optical axis adjustment (Back camera position setting)

Parking Assist Monitor System

for Initialization

for Calibration

• Parking assist ECU initialization
• Adjust steering angle
• Television camera assembly optical axis adjustment (Back camera position setting)

Panoramic View Monitor System

for Initialization

for Calibration

Perform headlight ECU sub-assembly LH initialization

Lighting system (for Gasoline Model with Cornering Light)

Front wheel alignment adjustment

Perform system variant learning and acceleration sensor zero point calibration.

• VSC is disabled or malfunctions
• DTCs are output
• Slip indicator light illuminates
• ABS warning light illuminates

(a) Remove the bolt and rear engine mounting insulator from the rear engine mounting bracket.

(b) Remove the bolt and wire harness clamp bracket from the rear engine mounting insulator.

(c) Disengage the clamp and remove the vacuum hose from the rear engine mounting insulator.