Toyota Avalon (XX50): Sub Radiator

Components

COMPONENTS

ILLUSTRATION

*1

RADIATOR ASSEMBLY

-

-

Installation

INSTALLATION

PROCEDURE

1. INSTALL RADIATOR ASSEMBLY

HINT:

The radiator (for inverter coolant) is part of the radiator (for Engine). If the radiator (for inverter coolant) needs to be replaced, replace the radiator assembly.

(a) Install the radiator assembly.

Click here

Removal

REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Front bumper assembly (w/ Panoramic view monitor system)	Front television camera view adjustment	Panoramic view monitor system	for Initialization for Calibration
Front bumper assembly (w/ Intuitive Parking Assist System)	Measurement of ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Intelligent clearance sonar system Intuitive parking assist system
Headlight ECU sub-assembly LH Headlight assembly LH	Synchronize the vehicle information	Lighting system (for HV Model with Cornering Light)
Swing grill actuator assembly Radiator shutter sub-assembly	Change grille shutter control mode and/or perform initialization	Grille shutter system

PROCEDURE

1. REMOVE RADIATOR ASSEMBLY

HINT:

The radiator (for inverter coolant) is part of the radiator (for Engine). If the radiator (for inverter coolant) needs to be replaced, replace the radiator assembly.

(a) Remove the radiator assembly.

Click here